Epoxy Floors in Richland, MS

A warehouse or truck shop floor is a piece of equipment. It takes forklift wheels, dropped parts, hydraulic fluid, fuel and cleaning chemicals, often all in the same week. The finish has to be chosen for that load, not for how it looks on day one.

For facilities in Richland, the first question is usually how long the space will be out of service. We plan around that from the start. See commercial floor coating for what we offer businesses.

Coating or polishing for a warehouse

A coating puts a sealed layer over the concrete, which helps where fluids and chemicals land. Concrete floor polishing hardens and smooths the concrete itself, with no film to wear through, and the area is usually back in use the same day. Many buildings use both: polished storage aisles and a coated maintenance area.

Shop floors that take jacks and fluids

Shop floors see point loads from jacks and stands, plus steady drips. An epoxy floor coating built for that use resists staining and makes spills easier to clean. If an older coating is already worn through in the traffic lanes, floor refinishing can bring it back after grinding.

• Diamond grinding to remove old coatings and contamination
• Moisture check before anything is applied
• Work scheduled in sections where operations allow

Keeping downtime short

Because 10X Epoxy is open 24 hours, installs can run overnight or across a weekend. Coated areas take about 24 hours before foot traffic and about 3 to 7 days before full use, depending on temperature. Those times go in the written estimate so your team can plan.

Every floor in Richland carries our workmanship guarantee, and every estimate is free and in writing.