Epoxy Floors in Brandon, MS

A two car garage mostly sees tires and the odd drip. A working shop sees floor jacks, jack stands, dropped wrenches, brake fluid and solvent. 10X Epoxy builds those floors thicker so they hold up to point loads and chemical spills.

We measure both buildings on the estimate visit and write up each one separately, so you can see what the shop needs compared with the garage.

Detached shop floors built for real work

For a shop, epoxy floor coating goes down at a heavier build than a typical garage. Jack stands and rolling toolboxes concentrate weight on small points, and fluids that sit overnight will stain bare concrete. A sealed floor wipes clean.

• Thicker build where jacks and stands sit
• Resistant to oil, brake fluid and common shop chemicals
• Easier to sweep and spot clean

Detached buildings and moisture

A detached shop slab is often poured separately and may have less protection from water running off the yard. After heavy rain, vapor rises through slabs, and a coating laid over a damp one can lift. We run a moisture check on every slab, and if one reads high we tell you before scheduling.

The garage and the rest of the property

The attached garage usually gets a standard garage floor epoxy coating. For an older shop floor that has been worn smooth or patched over the years, floor refinishing may be the better starting point.

What the Brandon estimate visit covers

Out in Brandon we usually look at more than one slab per property, so the visit runs a little longer. We measure each building, check moisture in each, note where the heavy equipment lives, and ask how the shop gets used day to day. You get a free written estimate with walk-on and full-use times for each floor.

Every floor in Brandon carries our workmanship guarantee, and every estimate is free and in writing.