Rankin County

Epoxy Floors in Pearl, MS

Pearl sits just east of Jackson across the Pearl River, along I-20 in Rankin County. 10X Epoxy coats garage floors in its established neighborhoods and floors for the service businesses along the interstate.

Get a free estimate Call (769) 200-4539

Workmanship guaranteeEvery floor we install
Open 24 hoursCall (769) 200-4539 any time
Owner on the jobKen Covington, owner
Written estimatesMeasured and priced on site

A lot of Pearl garages have spent years taking oil drips, tire marks and the odd spilled can of paint. That history is in the concrete, and a coating rolled straight over it will not last. The work starts with diamond grinding to open the surface and take off whatever is sitting on top.

Pearl is a short drive from our Jackson base, so a visit to measure your floor is easy to fit in. Every estimate is free and written down, and it covers the slab you actually have, not a guess. You can start with our garage floor epoxy coating page or ask for a visit.

Older garage slabs in Pearl

An established garage usually needs more prep than a new one. Oil soaks in, old sealers sit on the surface, and patches from past repairs grind differently from the original concrete. We grind the whole floor, check moisture, and tell you in writing when you can walk on it and when you can park. For a floor that has been coated before and is now peeling, floor refinishing is often the right starting point.

Oil and tire marks ground out before coating
Peeling paint or old sealer removed
Walk on in about 24 hours, park in about 3 to 7 days

Service bays and showroom floors along I-20

Businesses near the interstate tend to have floors that take vehicle traffic, fluids and constant cleaning. A commercial floor coating stands up to that, and a showroom that wants a clean, low maintenance look without a coating can go with concrete floor polishing, which is usually back in use the same day. We are open 24 hours, so the work can be planned around when your doors are open.

Questions from Pearl

Can a garage with deep oil stains still be coated?

Usually, yes. Grinding removes surface contamination and opens the concrete. Very heavy soaking gets checked at the estimate visit, and the written estimate says how it will be handled.

Can my service bay stay open while the floor is done?

We can often work in sections or outside business hours, since 10X Epoxy is open 24 hours. The schedule is agreed in writing before work starts.

My garage was coated before and it is peeling. Can it be fixed?

Yes. The failed coating is ground off down to sound concrete, then the floor is coated again. Peeling is usually a prep problem, which is why grinding comes first on every job.

Every floor in Pearl carries our workmanship guarantee, and every estimate is free and in writing.